How to Reset WiFi Repeater?

Resetting a WiFi router, repeater, extender or any other booster is a similar process. Some Networking brands provide buttons or some provides pinhole buttons to initiate reset process.

Usually reset process deletes all the device data and settings that you have made in it. It is used to dispel a big technical glitch or issue or make its performance good.

Here, you will get to know about how different brand networking boosters can reset within 10 minutes. Then, you will also get to know how to re-adjust settings of the WiFi repeater through their interface.

Reset WiFi Repeater

In this section, you will get to know about how to reset WiFi repeater using below given instruction.

• You have to find the RESET button on the device (it is given on side or along with Ethernet port).
• If it is a button then press it with your finger or if it pinhole button then use pin to long press it.
• After long pressing it, the reset process will start and after completing it, you have to re-adjust the repeater settings.

Let’s see how to configure the device if you have reset one of Netgear, Linksys or Wireless-N repeater.

Configure Repeater Again

We will start with the Netgear WiFi repeater configuration and then, provide steps to adjust settings of Linksys and Wireless-N signal repeater.

Netgear WiFi Repeater

If you have Netgear WiFi repeater, then use these down written instructions to re-adjust settings using its interface.

• Connect the computer first to the repeater through LAN cable.
• Click on updated web browser in the computer and search the mywifiext.net or IP 192.168.0.250.
• The login page will open on the screen where you have to type credentials (username and password).
• You have to use those credentials which you have used at the time of setup.
• Log in to it and reach to the interface and adjust the recommended settings.

Linksys WiFi Repeater

If you have Linksys WiFi repeater, then have a look at these down written steps to log in to the interface to configure the device.

• You have to access the interface through your computer.
• Just connect it through the LAN cable and open the web browser.
• Search the URL extender.linksys.com or IP address 192.168.1.1.
• The login page will open up where you have to enter the login credentials.
• Access the interface; here you can easily re-configure the extender.

Wireless-N WiFi Repeater

If you have a Wireless-N WiFi repeater, then just connect your computer or laptop to the repeater using LAN cable.

• Access an updated web browser and search login IP address 192.168.10.1.

• You will reach to a login page of the repeater interface, where just enter login credentials.
• Now, reach to the interface page where you can easily re-configure your repeater device.

So, these were the instructions which you can use to the reset your WiFi repeater and configure your device again.

Last Words

Here, we have come to the end of the blog, where you have seen and learned how to reset WiFi repeater. Then, we have discussed how to reconfigure your repeater even if it is of Netgear, Linksys, or Wireless-N WiFi repeater through its interface.